Serving sailors online since 1997
 
 

Recent Topics

Sailr99 at 9:59am 04.22.04
9/1063
Have a 1984 H-31 Anytime it rains, or I use a hose on the cabin sea hood, water leaks into the boat
Jim Doe at 9:36am 04.22.04
2/1059
Hi, I've got a tattered leach on my Cat-25 mainsail. Can anyone recommend a sail loft that does affo
David at 9:36am 04.22.04
6/1206
I have to replace a couple of the stanchion tubes on Cindino as they have been bent. But I can't for
Timmr at 9:19am 04.22.04
2/1050
I'm in the market for a new outboard.I can geta brand new Briggs and Stratton for a very good price.
Tim Welsh at 9:13am 04.22.04
5/1247
I just bought a new fluid evacuator and am going to use it this weekend to change the motor oil and
Andy B at 8:36am 04.22.04
4/1674
When I tried to launch my boat for the first time this season, I found that I could not fully retrac
Ed at 8:28am 04.22.04
5/1336
My problem is water leaking out from under the eyebrow when the boat heels or rocks. Seems the wate
Lou at 8:10am 04.22.04
2/851
I have an 18 hp Yanmar 2GM20F. At 2300-2500 rpms there is vibration. Below 2300 and above 2500 the v
Blair Bugher at 7:59am 04.22.04
2/2202
Am looking at a 1986 Catalina 27. There is evidence of moisture in the cabin bulkhead where the shro
Mark at 7:34am 04.22.04
4/1041
I recently purchased a 2004 C-350. I need to install forced air heating. Any reccomendations? Can
Richard at 7:17am 04.22.04
1/1098
Whew! I FINALLY snaked topping lift and reef lines into the Z-Spar boom on my 1987 H-23. What a pa
Kevin at 7:07am 04.22.04
29/2165
Here's my problem. I need to install a proper toping lift to replace the mickey mouse set-up current
David J. at 7:02am 04.22.04
5/1396
Here's a question for all experts... I have the standard 1-2-Both-Off battery switch but only 1 bat
Ray at 6:05am 04.22.04
1/988
HiGuys, I trailered my 26x over from Mayo Maryland to Woodbidge Virginia at the weekend and lost the
Jim at 6:00am 04.22.04
2/790
What was the most significant factor in choosing the boat you own? Price, availability, time spent
Peter Barton at 5:54am 04.22.04
2/987
Does anyone have the correct specs (length, thickness etc) for a main halyard? My old one is badly f
Charlie at 5:32am 04.22.04
3/836
During the windward part of a recent race a crew member disconnected the vang and placed it on the c
Charlie at 5:23am 04.22.04
1/993
It was suggested by a local "expert" that I install jib tracks on the roof of the cabin near the han
Frank at 5:10am 04.22.04
2/1145
Thank you in advance, this site I have found to be very helpful. In replacing the cable that raises
Sean Quine at 4:11am 04.22.04
4/1138
I have recently acquired a Hunter 25.5 with small outboard located in San Francisco. I would prefer

Recent Replies

Is this config acceptable?
DArcy at 10:11am 01.11.21
That's why you do NOT need one on a boat for grey water discharge. You WANT as straight a shot to t
Is this config acceptable?
smokey73 at 10:10am 01.11.21
One thing to consider is the portion of the hoses that are below the waterline. @Rich Stidger poste
Emergency Tiller
Hayden Watson at 10:09am 01.11.21
That is not a builder thing. They are built with an open hollow rudder shaft but some owners have t
Seatalk...whotalk..metalk...please talk?
DArcy at 10:06am 01.11.21
Does the ITC-5 work with your transducers? The Raymarine site implies it does not: If you don't have
Is this config acceptable?
Stu Jackson at 10:03am 01.11.21
So, no need for the loop so far. I appreciate the opinions on this. Justin, not so much opinions,
Outboard wedge
Roy 845 at 10:02am 01.11.21
I have one of these on my O'Day 22 with an 8hp Honda 4 stroke that works real well and was able to a
323 air conditioner
Ron20324 at 9:59am 01.11.21
Troy, what is that pole from the table to the overhead, next to the mast. Looks like a beach umbrell
Emergency Tiller
Ward H at 9:58am 01.11.21
The construction looks to me that a builder did not want water to come up the tube. So they just fi
Seatalk...whotalk..metalk...please talk?
Ward H at 9:57am 01.11.21
@Team118 Raymarine used to run a forum for questions and answers about their products. They close
Should I replace my old Yanmar motor mounts with OEMs or a newer design?
arf145 at 9:56am 01.11.21
I'm with Mainesail on that. I needed the mounts replaced on my last boat and the mechanic took it up
Looking for First 405 stanchion bases
Ron20324 at 9:54am 01.11.21
CRIPES ! The first thing we always say, is PICTURES.
AIS Receive Problem Identification
Brian D at 9:48am 01.11.21
@Rick D, it was the WRONG beer, I tell ya, geeze! Good job and thanks for the detailed update on th
Beneteau 323 Marine Gear Access
Ron20324 at 9:45am 01.11.21
Hhmmm... stbd of the engine is the potty on mine. But then again, I don't think you have the 3YM20 ?
Seatalk...whotalk..metalk...please talk?
Team118 at 9:01am 01.11.21
Yes, RM has the autopilot as the sole source of power, I was going to also do the math and see if I
Emergency Tiller
jssailem at 9:00am 01.11.21
The construction looks to me that a builder did not want water to come up the tube. So they just fil
AIS Receive Problem Identification
jssailem at 8:47am 01.11.21
:plus:Yep...
AIS Receive Problem Identification
dlochner at 8:46am 01.11.21
This might help. It is from Marine Traffic. https://help.marinetraffic.com/hc/en-us/articles/20542
Seatalk...whotalk..metalk...please talk?
jssailem at 8:45am 01.11.21
Looks about right. I did not do the math, but there is a need to have balance in the system with reg
cleaning sunbrella   (1)
Justin_NSA at 8:33am 01.11.21
303 products are great! https://www.fisheriessupply.com/303-protectants-303-high-tech-fabric-guard
AIS Receive Problem Identification
jssailem at 8:33am 01.11.21
This might help. It is from Marine Traffic. https://help.marinetraffic.com/hc/en-us/articles/205426

Copyright 1997-2026 SB Owners, LLC
All rights reserved.

is not endorsed by or affiliated with any sailboat manufacturer.