Serving sailors online since 1997
 
 

Recent Topics

David at 9:36am 04.22.04
6/1160
I have to replace a couple of the stanchion tubes on Cindino as they have been bent. But I can't for
Timmr at 9:19am 04.22.04
2/1003
I'm in the market for a new outboard.I can geta brand new Briggs and Stratton for a very good price.
Tim Welsh at 9:13am 04.22.04
5/1203
I just bought a new fluid evacuator and am going to use it this weekend to change the motor oil and
Andy B at 8:36am 04.22.04
4/1590
When I tried to launch my boat for the first time this season, I found that I could not fully retrac
Ed at 8:28am 04.22.04
5/1288
My problem is water leaking out from under the eyebrow when the boat heels or rocks. Seems the wate
Lou at 8:10am 04.22.04
2/819
I have an 18 hp Yanmar 2GM20F. At 2300-2500 rpms there is vibration. Below 2300 and above 2500 the v
Blair Bugher at 7:59am 04.22.04
2/2117
Am looking at a 1986 Catalina 27. There is evidence of moisture in the cabin bulkhead where the shro
Mark at 7:34am 04.22.04
4/1018
I recently purchased a 2004 C-350. I need to install forced air heating. Any reccomendations? Can
Richard at 7:17am 04.22.04
1/1072
Whew! I FINALLY snaked topping lift and reef lines into the Z-Spar boom on my 1987 H-23. What a pa
Kevin at 7:07am 04.22.04
29/2100
Here's my problem. I need to install a proper toping lift to replace the mickey mouse set-up current
David J. at 7:02am 04.22.04
5/1370
Here's a question for all experts... I have the standard 1-2-Both-Off battery switch but only 1 bat
Ray at 6:05am 04.22.04
1/946
HiGuys, I trailered my 26x over from Mayo Maryland to Woodbidge Virginia at the weekend and lost the
Jim at 6:00am 04.22.04
2/744
What was the most significant factor in choosing the boat you own? Price, availability, time spent
Peter Barton at 5:54am 04.22.04
2/952
Does anyone have the correct specs (length, thickness etc) for a main halyard? My old one is badly f
Charlie at 5:32am 04.22.04
3/801
During the windward part of a recent race a crew member disconnected the vang and placed it on the c
Charlie at 5:23am 04.22.04
1/956
It was suggested by a local "expert" that I install jib tracks on the roof of the cabin near the han
Frank at 5:10am 04.22.04
2/1128
Thank you in advance, this site I have found to be very helpful. In replacing the cable that raises
Sean Quine at 4:11am 04.22.04
4/1053
I have recently acquired a Hunter 25.5 with small outboard located in San Francisco. I would prefer
Marty Stenzler at 1:02am 04.22.04
5/1490
i have a 1998 320 and the pivioting tang that connect the boom vang to the mast has broken off. i h
Steve C at 12:59am 04.22.04
5/1298
My depth sounder went on the brink last year, started displaying - - , then it would work for a whil

Recent Replies

Interesting concept?
kappykaplan at 6:49am 11.22.20
corned beef with Guinness Yummy!
Anti-fouling wax
dlochner at 6:45am 11.22.20
Practical Sailor just sent out an email about using acids to descale and clean parts. Interesting re
Vendée Globe?
jon hansen at 6:44am 11.22.20
https://www.alexthomsonracing.com
Interfacing B&G MFD with Raymarine X5 autopilot?
dlochner at 6:43am 11.22.20
The Raymarine X5 is the computer that controls the AP motor. It has NMEA1803 and Seatalk inputs.
Vendée Globe?
shemandr at 6:38am 11.22.20
Yep, Hugo seems wounded. Down to 3 kts. and only 1.8 vmg. Sam is at the back of what I would call
Honda 9.9 - Is there an oil filter?
twistedskipper at 6:32am 11.22.20
Interesting, though off topic, that in 1998 the 9.9 was a derated version of the 15, but by 2001 the
Deck step repair
junkydave at 6:32am 11.22.20
Thanks for response. Will have to look closely at the cabin top but, don't believe top has dropped.
Reapplying gelcoat
dlochner at 6:31am 11.22.20
I prefer the gelcoat without wax. This allows for multiple coats without sanding or needing to remov
Interfacing B&G MFD with Raymarine X5 autopilot?
michaelapk at 6:30am 11.22.20
The Raymarine X5 is the computer that controls the AP motor. It has NMEA1803 and Seatalk inputs.
Dirty Jobs Tonight
jssailem at 6:25am 11.22.20
Interfacing B&G MFD with Raymarine X5 autopilot?
dlochner at 6:25am 11.22.20
How is the RM AP controlled? If it has its own controller that is capable of using waypoint and wind
Deck step repair
jssailem at 6:15am 11.22.20
Welcome to the forum. I enjoy the strong construction of my CAL 35C boat. Depending on the year, CAL
Reapplying gelcoat
Hydro Therapy at 6:13am 11.22.20
8 years later and the job still looks like the day I applied it.
Reapplying gelcoat
SailingLoto at 6:11am 11.22.20
dlochner did a good job of summarizing gelcoat. do not reduce it with acetone. acetone breaks gelc
Anti-fouling wax
dlochner at 6:09am 11.22.20
Good idea. (I'm talking to you, scientists.) In the meantime, I dissolve a tablespoon or so of this
ATN gennaker
justsomeguy at 6:03am 11.22.20
@jssailem 's right about @garymalmgren and @dlochner being right. Enjoy the sail. Challenging and f
Advice on cabin interior wall replacement project
michaelapk at 6:02am 11.22.20
Thanks! very helpful.
Sending Unit Leaking
Kings Gambit at 6:01am 11.22.20
As John described, I could also empty my fuel tank by removing the primary fuel filter. I have a fue
ATN gennaker
jssailem at 5:57am 11.22.20
yep. @garymalmgren and @dlochner nailed it. :biggrin:
Sending Unit Leaking
jssailem at 5:52am 11.22.20
I would just pump the extra fuel out. Save it to pour back in to the tank later when you have room

Copyright 1997-2025 SB Owners, LLC
All rights reserved.

is not endorsed by or affiliated with any sailboat manufacturer.