$50,000 US Make offer
The owner bought this boat in 2010
General condition and any additional information
Not obligated to a yacht broker at present.
My original 2010 yacht survey available on request.
Standard features
Design:
Ted Brewer Bulldog
Custom built cutter rigged for offshore cruising built 1989
Radius chine construction, moderate draft, long waterline
Cutaway forefoot, high freeboard
Transom/keel hung rudder
TED BREWER YACHT DESIGNS, LTD
217 Edith Point Road
Anacortes, WA 98221
https://www.tedbrewer.com/
Dimensions:
LOA 31 ft. LOD 30 ft. LWL 26 ft. Beam 10 ft. 5 inches Draft 4 ft.11 inches
Ballast 5000 poured lead
Displacement 12,000 lbs
Sail Area 528 sq.ft.
Construction Aluminum 5086 alloy
Displacement/Length Ratio 305
Sail Area/Displacement Ratio 16:1
Comfort ratio (Ted Brewer formula): 29.8
75 gallons fresh water in three keel tanks
58 gallons diesel fuel in two aft tanks
Propulsion:
Yanmar 3GM30F (1991) 1123 hours (as of 12/21);
PSS dripless shaft seal and tail shaft professionally installed and aligned;
Flawless run up to 3400 rpm; cruises at 6.3 kts @ 2400 rpm (flat sea);
Starts first time, no smoke, mixing elbow changed and SS spare;
All belts, synthetic oil, fuel biocide, filters and impellers changed on routine scheduled maintenance;
Forespar marelon inlet and outlet seacocks;
Electric and manual fuel gauges;
Racor 500fg2 30 micron primary fuel filter with vacuum gauge;
Racor 500ma 30 micron series fuel filter;
Manuals, spares included;
Sails and rigging:
Jib and staysail on Harken roller furling
Unused spare furling jib and staysails
H and H 0.75 oz. asymmetrical spinnaker
Two sets ST Harken cockpit coming 2-speed winches (#30 and #40)
Mainsail in good condition with twin reef points
Mast mount Harken #20 ST winch and clutches
1st and 2nd boom mounted reefing winches
Bridge deck mount Harken #15 ST winch and clutches
Slab reefing and lazy jacks
Rigid adjustable boom vang
Running backstays on titanium blocks
Two (spinnaker/whisker) poles w/mast mounting track
Extensive ground tackle and fenders
Electric/manual Simpson windlass
110 ft. chain 5/16 inches
190 ft. 3/4 nylon twist rode
Two SS bow anchor rollers
Spade S-80 33# (new) and Spade S-100 44# anchors
Fortress FX-37 aluminum anchor on 12 chain and 75 ft. nylon rode
Two cockpit lazarettes with fenders, shore tackle
Two 10 gal propane bottles in safety locker with overboard vent
Electronics :
Garmin GPSMAP 840 xs with sonar transducer and blue charts (2015)
Garmin GPSMAP 741xs repeater at chart table
ICOM M-506 marine VHF radio with dedicated antenna (2015)
ICOM MA-500TR AIS transponder with dedicated antenna (2015)
ICOM ICOM IC-M710 MF/HF Marine Transceiver
ICOM AT-130 Antenna (not installed)
Standard Horizon HX870 VHF handheld (2015)
Raymarine ST-4000 tiller autopilot with SPX-5 Course Computer
Xantrex Freedom 458 2500W 12VDC modified sine wave charger/inverter
Lifeline AGM GPL-27T 845 CCA each of four house batteries (2013)
Lifeline AGM GPL-24T 800 CCA dedicated starter battery (2020)
Yanmar 85 amp alternator
Vitron Blue Energy MPPT charge controller and gauge
Radar arch:
Garmin GMR hd 18 inches radome (2016)
Garmin GXM 53 Sirius XM weather antenna (2015)
85 watt Solar/KISS wind generator with smart controller
Engine hoist and davits on arch
Fishing pole attachment
Magma propane grill
Galley:
Force 10 three burner stove and oven
IsoTemp hot water heater with valve to engine heating
Dometic CU Adler Barbour Fridge/freezer with water cooler
Dometic DTU 10K marine air/heater with SMX controller
Ample stores lockers beneath port and starboard berths
10 opening/latching drawer near galley and chart table
8 opening lockers for cookware, bulk stowage and dive gear
Safety:
Collision bulkhead forward at waterline
Rule-Mate 1100-A automatic electric bilge pump (1100 GPH) (2017)
Jabsco 36600 electric bilge pump (475 GH) (new diaphragms)
Rule switched 3800 GPH 17A (D) electric bilge pump
Whale Gusher 30 manual bilge pump (1860 GPH) (new diaphragms)
Through hole bungs
MOB pole, Lifesling rescue system, life ring, PFD
Lifelines, bow pulpit, Bimini and dodger handholds
Mast steps and mast pulpit
Aluminum slotted toe rail with scuppers
Full length polycarbonate rub rail
KiwiGrip non-skid deck paint throughout
Custom welded swim step/rudder guard with dive ladder
Rechargeable 2900 lumen LED spotlight
Deck and cockpit lighting
Fully equipped USCG approved navigation/anchor lighting
Teak drainable cockpit seating
Teak companionway ladder
Teak cabin sole
Full length cabin handrails and grab bars
Stove railing and adjustable pot holders
Two vices mounted on centerline workbench
Fire extinguishers
Steering:
Tiller with spare
Raymarine ST-4000 with programable computer course controller
Monitor wind vane with various sized vane blade
Vane attachment to mount auto-tiller
Full cabin width mainsail boom traveler
Navigation:
Full sized chart table with full sized storage under
Plastimo Contest 101Tactical Compass bridgedeck
Plastimo Contest 101 Tactical Compass cabin bulkhead
Barometer/chronometer x two; barometer stand alone
Aqua Signal Navigation Tricolor Anchor Pedestal Mount Navigation Light
Bicolor pulpit mounted navigation light with stern light
Accommodation:
V-berth forward with storage under and forward
Quarter berth to port, settee berth and pilot berth to starboard
AirHead composting toilet
Hanging clothing bar and locker
Dinghy:
(see addendum: new Highfield UL-290 rigid aluminum inflatable)
Suzuki 2.2hp lightweight 2 stroke gas outboard with manual and parts
British Seagull 6hp 2 stroke outboard with clutch
Improvements:
New never used Highfield UL-290 rigid aluminum inflatable dinghy (see photos)
New Harken top down Reflex 1 asymetrical spinnaker furler
Welded dinghy/engine hoist davits to radar arch (see photo)
Bottom paint and zincs May, 2019
Stereo/CD with Bose speakers
Also:
ACR personal and vessel EPIRB x 2 (2015)
Fishing poles and tackle
Spare parts, filters, belts
Spare sails including riding sail
Extensive ground tackle
Price:
$50,000 with negotiable accoutrements
Location:
Coconut Grove, Miami, Florida, USA